diff options
Diffstat (limited to 'docs/getting_started_make_guide.md')
| -rw-r--r-- | docs/getting_started_make_guide.md | 2 |
1 files changed, 1 insertions, 1 deletions
diff --git a/docs/getting_started_make_guide.md b/docs/getting_started_make_guide.md index 02216875c8..70390a5105 100644 --- a/docs/getting_started_make_guide.md +++ b/docs/getting_started_make_guide.md @@ -14,7 +14,7 @@ The full syntax of the `make` command is `<keyboard_folder>:<keymap>:<target>`, The `<target>` means the following * If no target is given, then it's the same as `all` below * `all` compiles as many keyboard/revision/keymap combinations as specified. For example, `make planck/rev4:default` will generate a single .hex, while `make planck/rev4:all` will generate a hex for every keymap available to the planck. -* `flash`, `dfu`, `teensy`, `avrdude`, `dfu-util`, or `bootloadHID` compile and upload the firmware to the keyboard. If the compilation fails, then nothing will be uploaded. The programmer to use depends on the keyboard. For most keyboards it's `dfu`, but for ChibiOS keyboards you should use `dfu-util`, and `teensy` for standard Teensys. To find out which command you should use for your keyboard, check the keyboard specific readme. +* `flash`, `dfu`, `teensy`, `avrdude`, `dfu-util`, or `bootloadhid` compile and upload the firmware to the keyboard. If the compilation fails, then nothing will be uploaded. The programmer to use depends on the keyboard. For most keyboards it's `dfu`, but for ChibiOS keyboards you should use `dfu-util`, and `teensy` for standard Teensys. To find out which command you should use for your keyboard, check the keyboard specific readme. Visit the [Flashing Firmware](flashing.md) guide for more details of the available bootloaders. * **Note**: some operating systems need privileged access for these commands to work. This means that you may need to setup [`udev rules`](faq_build.md#linux-udev-rules) to access these without root access, or to run the command with root access (`sudo make planck/rev4:default:flash`). * `clean`, cleans the build output folders to make sure that everything is built from scratch. Run this before normal compilation if you have some unexplainable problems. |