blob: 0df34f204d5c61f73da13930fc92eda35265d8f7 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
|
// Copyright 2021 Nick Brassel (@tzarc)
// SPDX-License-Identifier: GPL-2.0-or-later
#pragma once
#include "gpio.h"
#include "qp_internal.h"
////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////
// Quantum Painter SSD1351 configurables (add to your keyboard's config.h)
#ifndef SSD1351_NUM_DEVICES
/**
* @def This controls the maximum number of SSD1351 devices that Quantum Painter can communicate with at any one time.
* Increasing this number allows for multiple displays to be used.
*/
# define SSD1351_NUM_DEVICES 1
#endif
////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////
// Quantum Painter SSD1351 device factories
#ifdef QUANTUM_PAINTER_SSD1351_SPI_ENABLE
/**
* Factory method for an SSD1351 SPI OLED device.
*
* @param panel_width[in] the width of the display panel
* @param panel_height[in] the height of the display panel
* @param chip_select_pin[in] the GPIO pin used for SPI chip select
* @param dc_pin[in] the GPIO pin used for D/C control
* @param reset_pin[in] the GPIO pin used for RST
* @param spi_divisor[in] the SPI divisor to use when communicating with the display
* @param spi_mode[in] the SPI mode to use when communicating with the display
* @return the device handle used with all drawing routines in Quantum Painter
*/
painter_device_t qp_ssd1351_make_spi_device(uint16_t panel_width, uint16_t panel_height, pin_t chip_select_pin, pin_t dc_pin, pin_t reset_pin, uint16_t spi_divisor, int spi_mode);
#endif // QUANTUM_PAINTER_SSD1351_SPI_ENABLE
|
