diff options
Diffstat (limited to 'keyboards/studiokestra/galatea/readme.md')
-rw-r--r-- | keyboards/studiokestra/galatea/readme.md | 30 |
1 files changed, 16 insertions, 14 deletions
diff --git a/keyboards/studiokestra/galatea/readme.md b/keyboards/studiokestra/galatea/readme.md index 1268c596bf..580815fa63 100644 --- a/keyboards/studiokestra/galatea/readme.md +++ b/keyboards/studiokestra/galatea/readme.md @@ -1,27 +1,29 @@ -# Galatea +# studiokestra/galatea + +![studiokestra/galatea](https://i.imgur.com/juPhV1xh.png) TKL H87/88c compatible PCB with support for the most common layouts. * Keyboard Maintainer: [Studio Kestra](https://github.com/studiokestra/) -* Hardware Supported: [studiokestra.ca/galatea](https://studiokestra.ca/galatea/) -* Hardware Availability: In-Stock Sale (Dec 2021) +* Hardware Supported: Most H87C compatible keyboards +* Hardware Availability: https://RNDKBD.com; https://geon.works/ * Rev1 firmware is used for Galatea PCBs with no RGB underglow. -* Rev2 firmware is used for Galatea PCBs with RGB underglow. +* Rev2 firmware is used for Galatea PCBs with RGB underglow. -## Bootload Sequence +Make example for this keyboard (after setting up your build environment): -There are 3 ways to put the board in bootloader mode: + make studiokestra/galatea/rev1:default -- Hold the top-left key (typically `Esc`) while plugging in the USB cable, OR -- While the PCB is plugged into the PC, press the physical `RESET` button on the back of the board, OR -- With the default layout, toggle Layer 1 and press the `R` key. +Flashing example for this keyboard: -## Compiling Firmware + make studiokestra/galatea/rev1:default:flash -Make example for this keyboard (after setting up your build environment): +See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs). - make studiokestra/galatea/rev1:default +## Bootloader -If no revision is specified, it will build rev1 firmware by default. +Enter the bootloader in 3 ways: -See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs). +* **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard +* **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead +* **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available |