From 405dea01bef215a0b79524e4ff74364f1bcfeadf Mon Sep 17 00:00:00 2001 From: fauxpark Date: Fri, 9 Aug 2019 07:09:54 +1000 Subject: Add some defaults for ATmega32A to mcu_selection.mk (#6253) * Add some defaults for ATmega32A to mcu_selection.mk * Remove boilerplate from templates * Relax INTERRUPT_CONTROL_ENDPOINT and PROGRAM_CMD * Apply suggestions from code review Co-Authored-By: Drashna Jaelre --- quantum/template/avr/rules.mk | 36 ------------------------------------ 1 file changed, 36 deletions(-) (limited to 'quantum/template/avr/rules.mk') diff --git a/quantum/template/avr/rules.mk b/quantum/template/avr/rules.mk index 133c9e363b..50deba92cf 100644 --- a/quantum/template/avr/rules.mk +++ b/quantum/template/avr/rules.mk @@ -1,42 +1,6 @@ # MCU name MCU = atmega32u4 -# Processor frequency. -# This will define a symbol, F_CPU, in all source code files equal to the -# processor frequency in Hz. You can then use this symbol in your source code to -# calculate timings. Do NOT tack on a 'UL' at the end, this will be done -# automatically to create a 32-bit value in your source code. -# -# This will be an integer division of F_USB below, as it is sourced by -# F_USB after it has run through any CPU prescalers. Note that this value -# does not *change* the processor frequency - it should merely be updated to -# reflect the processor speed set externally so that the code can use accurate -# software delays. -F_CPU = 16000000 - - -# -# LUFA specific -# -# Target architecture (see library "Board Types" documentation). -ARCH = AVR8 - -# Input clock frequency. -# This will define a symbol, F_USB, in all source code files equal to the -# input clock frequency (before any prescaling is performed) in Hz. This value may -# differ from F_CPU if prescaling is used on the latter, and is required as the -# raw input clock is fed directly to the PLL sections of the AVR for high speed -# clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL' -# at the end, this will be done automatically to create a 32-bit value in your -# source code. -# -# If no clock division is performed on the input clock inside the AVR (via the -# CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU. -F_USB = $(F_CPU) - -# Interrupt driven control endpoint task(+60) -OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT - # Bootloader selection # Teensy halfkay -- cgit v1.2.3