From 821563417565776d2dc3a02b0265e6fcd5218739 Mon Sep 17 00:00:00 2001 From: tmk Date: Mon, 11 Feb 2013 22:57:40 +0900 Subject: Now includes LUFA-120730 in repository --- .../LUFA/DoxygenPages/ProgrammingApps.txt | 30 ++++++++++++++++++++++ 1 file changed, 30 insertions(+) create mode 100644 protocol/lufa/LUFA-120730/LUFA/DoxygenPages/ProgrammingApps.txt (limited to 'protocol/lufa/LUFA-120730/LUFA/DoxygenPages/ProgrammingApps.txt') diff --git a/protocol/lufa/LUFA-120730/LUFA/DoxygenPages/ProgrammingApps.txt b/protocol/lufa/LUFA-120730/LUFA/DoxygenPages/ProgrammingApps.txt new file mode 100644 index 0000000000..6ff1856766 --- /dev/null +++ b/protocol/lufa/LUFA-120730/LUFA/DoxygenPages/ProgrammingApps.txt @@ -0,0 +1,30 @@ +/** \file + * + * This file contains special DoxyGen information for the generation of the main page and other special + * documentation pages. It is not a project source file. + */ + +/** \page Page_ProgrammingApps Programming an Application into a USB AVR + * + * Once you have built an application, you will need a way to program in the resulting ".HEX" file (and, if your + * application uses EEPROM variables with initial values, also a ".EEP" file) into your USB AVR. Normally, the + * reprogramming of an AVR device must be performed using a special piece of programming hardware, through one of the + * supported AVR programming protocols - ISP, HVSP, HVPP, JTAG, dW or PDI. This can be done through a custom programmer, + * a third party programmer, or an official Atmel AVR tool - for more information, see the atmel.com website. + * + * Alternatively, you can use the bootloader. From the Atmel factory, each USB AVR comes preloaded with the Atmel + * DFU (Device Firmware Update) class bootloader, a small piece of AVR firmware which allows the remainder of the + * AVR to be programmed through a non-standard interface such as the serial USART port, SPI, or (in this case) USB. + * Bootloaders have the advantage of not requiring any special hardware for programming, and cannot usually be erased + * or broken without an external programming device. They have disadvantages however; they cannot change the fuses of + * the AVR (special configuration settings that control the operation of the chip itself) and a small portion of the + * AVR's FLASH program memory must be reserved to contain the bootloader firmware, and thus cannot be used by the + * loaded application. + * + * If you wish to use the DFU bootloader to program in your application, refer to your DFU programmer's documentation. + * Atmel provides a free utility called FLIP which is USB AVR compatible, and an open source (Linux compatible) + * alternative exists called "dfu-programmer". + * + * \see \ref Page_BuildModule_DFU for information on the LUFA build system DFU module, for automatic DFU bootloader + * programming makefile targets. + */ -- cgit v1.2.3