1 files changed, 0 insertions, 30 deletions
diff --git a/protocol/lufa/LUFA-120730/LUFA/DoxygenPages/ProgrammingApps.txt b/protocol/lufa/LUFA-120730/LUFA/DoxygenPages/ProgrammingApps.txt
deleted file mode 100644
index 6ff1856766..0000000000
--- a/protocol/lufa/LUFA-120730/LUFA/DoxygenPages/ProgrammingApps.txt
+++ /dev/null
@@ -1,30 +0,0 @@
-/** \file
- *
- *  This file contains special DoxyGen information for the generation of the main page and other special
- *  documentation pages. It is not a project source file.
- */
-
-/** \page Page_ProgrammingApps Programming an Application into a USB AVR
- *
- *  Once you have built an application, you will need a way to program in the resulting ".HEX" file (and, if your
- *  application uses EEPROM variables with initial values, also a ".EEP" file) into your USB AVR. Normally, the
- *  reprogramming of an AVR device must be performed using a special piece of programming hardware, through one of the
- *  supported AVR programming protocols - ISP, HVSP, HVPP, JTAG, dW or PDI. This can be done through a custom programmer,
- *  a third party programmer, or an official Atmel AVR tool - for more information, see the <a>atmel.com</a> website.
- *
- *  Alternatively, you can use the bootloader. From the Atmel factory, each USB AVR comes preloaded with the Atmel
- *  DFU (Device Firmware Update) class bootloader, a small piece of AVR firmware which allows the remainder of the
- *  AVR to be programmed through a non-standard interface such as the serial USART port, SPI, or (in this case) USB.
- *  Bootloaders have the advantage of not requiring any special hardware for programming, and cannot usually be erased
- *  or broken without an external programming device. They have disadvantages however; they cannot change the fuses of
- *  the AVR (special configuration settings that control the operation of the chip itself) and a small portion of the
- *  AVR's FLASH program memory must be reserved to contain the bootloader firmware, and thus cannot be used by the
- *  loaded application.
- *
- *  If you wish to use the DFU bootloader to program in your application, refer to your DFU programmer's documentation.
- *  Atmel provides a free utility called FLIP which is USB AVR compatible, and an open source (Linux compatible)
- *  alternative exists called "dfu-programmer".
- *
- *  \see \ref Page_BuildModule_DFU for information on the LUFA build system DFU module, for automatic DFU bootloader
- *  programming makefile targets.
- */