diff options
Diffstat (limited to 'platforms/chibios/drivers/vendor')
| -rw-r--r-- | platforms/chibios/drivers/vendor/RP/RP2040/ps2_vendor.c | 271 |
1 files changed, 271 insertions, 0 deletions
diff --git a/platforms/chibios/drivers/vendor/RP/RP2040/ps2_vendor.c b/platforms/chibios/drivers/vendor/RP/RP2040/ps2_vendor.c new file mode 100644 index 0000000000..937fa5de6f --- /dev/null +++ b/platforms/chibios/drivers/vendor/RP/RP2040/ps2_vendor.c @@ -0,0 +1,271 @@ +// Copyright 2022 Marek Kraus (@gamelaster) +// SPDX-License-Identifier: GPL-2.0-or-later + +#include "quantum.h" + +#include "hardware/pio.h" +#include "hardware/clocks.h" +#include "ps2.h" +#include "print.h" + +#if !defined(MCU_RP) +# error PIO Driver is only available for Raspberry Pi 2040 MCUs! +#endif + +#if defined(PS2_ENABLE) +# if defined(PS2_MOUSE_ENABLE) +# if !defined(PS2_MOUSE_USE_REMOTE_MODE) +# define BUFFERED_MODE_ENABLE +# endif +# else // PS2 Keyboard +# define BUFFERED_MODE_ENABLE +# endif +#endif + +#if PS2_DATA_PIN + 1 != PS2_CLOCK_PIN +# error PS/2 Clock pin must be followed by data pin! +#endif + +static inline void pio_serve_interrupt(void); + +#if defined(PS2_PIO_USE_PIO1) +static const PIO pio = pio1; + +OSAL_IRQ_HANDLER(RP_PIO1_IRQ_0_HANDLER) { + OSAL_IRQ_PROLOGUE(); + pio_serve_interrupt(); + OSAL_IRQ_EPILOGUE(); +} +#else +static const PIO pio = pio0; + +OSAL_IRQ_HANDLER(RP_PIO0_IRQ_0_HANDLER) { + OSAL_IRQ_PROLOGUE(); + pio_serve_interrupt(); + OSAL_IRQ_EPILOGUE(); +} +#endif + +#define PS2_WRAP_TARGET 0 +#define PS2_WRAP 20 + +// clang-format off +static const uint16_t ps2_program_instructions[] = { + // .wrap_target + 0x00c7, // 0: jmp pin, 7 + 0xe02a, // 1: set x, 10 + 0x2021, // 2: wait 0 pin, 1 + 0x4001, // 3: in pins, 1 + 0x20a1, // 4: wait 1 pin, 1 + 0x0042, // 5: jmp x--, 2 + 0x0000, // 6: jmp 0 + 0x00e9, // 7: jmp !osre, 9 + 0x0000, // 8: jmp 0 + 0xff81, // 9: set pindirs, 1 [31] + 0xe280, // 10: set pindirs, 0 [2] + 0xe082, // 11: set pindirs, 2 + 0x2021, // 12: wait 0 pin, 1 + 0xe029, // 13: set x, 9 + 0x6081, // 14: out pindirs, 1 + 0x20a1, // 15: wait 1 pin, 1 + 0x2021, // 16: wait 0 pin, 1 + 0x004e, // 17: jmp x--, 14 + 0xe083, // 18: set pindirs, 3 + 0x2021, // 19: wait 0 pin, 1 + 0x20a1, // 20: wait 1 pin, 1 + // .wrap +}; +// clang-format on + +static const struct pio_program ps2_program = { + .instructions = ps2_program_instructions, + .length = 21, + .origin = -1, +}; + +static int state_machine = -1; +static thread_reference_t tx_thread = NULL; + +#define BUFFER_SIZE 32 +static input_buffers_queue_t pio_rx_queue; +static __attribute__((aligned(4))) uint8_t pio_rx_buffer[BQ_BUFFER_SIZE(BUFFER_SIZE, sizeof(uint32_t))]; + +uint8_t ps2_error = PS2_ERR_NONE; + +void pio_serve_interrupt(void) { + uint32_t irqs = pio->ints0; + + if (irqs & (PIO_IRQ0_INTF_SM0_RXNEMPTY_BITS << state_machine)) { + osalSysLockFromISR(); + uint32_t* frame_buffer = (uint32_t*)ibqGetEmptyBufferI(&pio_rx_queue); + if (frame_buffer == NULL) { + osalSysUnlockFromISR(); + return; + } + *frame_buffer = pio_sm_get(pio, state_machine); + ibqPostFullBufferI(&pio_rx_queue, sizeof(uint32_t)); + osalSysUnlockFromISR(); + } + + if (irqs & (PIO_IRQ0_INTF_SM0_TXNFULL_BITS << state_machine)) { + pio_set_irq0_source_enabled(pio, pis_sm0_tx_fifo_not_full + state_machine, false); + osalSysLockFromISR(); + osalThreadResumeI(&tx_thread, MSG_OK); + osalSysUnlockFromISR(); + } +} + +void ps2_host_init(void) { + ibqObjectInit(&pio_rx_queue, false, pio_rx_buffer, sizeof(uint32_t), BUFFER_SIZE, NULL, NULL); + uint pio_idx = pio_get_index(pio); + + hal_lld_peripheral_unreset(pio_idx == 0 ? RESETS_ALLREG_PIO0 : RESETS_ALLREG_PIO1); + + state_machine = pio_claim_unused_sm(pio, true); + if (state_machine < 0) { + dprintln("ERROR: Failed to acquire state machine for PS/2!"); + ps2_error = PS2_ERR_NODATA; + return; + } + + uint offset = pio_add_program(pio, &ps2_program); + + pio_sm_config c = pio_get_default_sm_config(); + sm_config_set_wrap(&c, offset + PS2_WRAP_TARGET, offset + PS2_WRAP); + + // Set pindirs to input (output enable is inverted below) + pio_sm_set_consecutive_pindirs(pio, state_machine, PS2_DATA_PIN, 2, true); + sm_config_set_clkdiv(&c, (float)clock_get_hz(clk_sys) / (200.0f * KHZ)); + sm_config_set_set_pins(&c, PS2_DATA_PIN, 2); + sm_config_set_out_pins(&c, PS2_DATA_PIN, 1); + sm_config_set_out_shift(&c, true, true, 10); + sm_config_set_in_shift(&c, true, true, 11); + sm_config_set_jmp_pin(&c, PS2_CLOCK_PIN); + sm_config_set_in_pins(&c, PS2_DATA_PIN); + + // clang-format off + iomode_t pin_mode = PAL_RP_PAD_IE | + PAL_RP_GPIO_OE | + PAL_RP_PAD_SLEWFAST | + PAL_RP_PAD_DRIVE12 | + // Invert output enable so that pindirs=1 means input + // and indirs=0 means output. This way, out pindirs + // works correctly with the open-drain PS/2 interface. + // Setting pindirs=1 effectively pulls the line high, + // due to the pull-up resistor, while pindirs=0 pulls + // the line low. + PAL_RP_IOCTRL_OEOVER_DRVINVPERI | + (pio_idx == 0 ? PAL_MODE_ALTERNATE_PIO0 : PAL_MODE_ALTERNATE_PIO1); + // clang-format on + + palSetLineMode(PS2_DATA_PIN, pin_mode); + palSetLineMode(PS2_CLOCK_PIN, pin_mode); + + pio_set_irq0_source_enabled(pio, pis_sm0_rx_fifo_not_empty + state_machine, true); + pio_sm_init(pio, state_machine, offset, &c); + +#if defined(PS2_PIO_USE_PIO1) + nvicEnableVector(RP_PIO1_IRQ_0_NUMBER, CORTEX_MAX_KERNEL_PRIORITY); +#else + nvicEnableVector(RP_PIO0_IRQ_0_NUMBER, CORTEX_MAX_KERNEL_PRIORITY); +#endif + + pio_sm_set_enabled(pio, state_machine, true); +} + +static int bit_parity(int x) { + return !__builtin_parity(x); +} + +uint8_t ps2_host_send(uint8_t data) { + uint32_t frame = 0b1000000000; + frame = frame | data; + + if (bit_parity(data)) { + frame = frame | (1 << 8); + } + + pio_sm_put(pio, state_machine, frame); + + msg_t msg = MSG_OK; + osalSysLock(); + while (pio_sm_is_tx_fifo_full(pio, state_machine)) { + pio_set_irq0_source_enabled(pio, pis_sm0_tx_fifo_not_full + state_machine, true); + msg = osalThreadSuspendTimeoutS(&tx_thread, TIME_MS2I(100)); + if (msg < MSG_OK) { + pio_set_irq0_source_enabled(pio, pis_sm0_tx_fifo_not_full + state_machine, false); + ps2_error = PS2_ERR_NODATA; + osalSysUnlock(); + return 0; + } + } + osalSysUnlock(); + + return ps2_host_recv_response(); +} + +static uint8_t ps2_get_data_from_frame(uint32_t frame) { + uint8_t data = (frame >> 22) & 0xFF; + uint32_t start_bit = (frame & 0b00000000001000000000000000000000) ? 1 : 0; + uint32_t parity_bit = (frame & 0b01000000000000000000000000000000) ? 1 : 0; + uint32_t stop_bit = (frame & 0b10000000001000000000000000000000) ? 1 : 0; + + if (start_bit != 0) { + ps2_error = PS2_ERR_STARTBIT1; + return 0; + } + + if (parity_bit != bit_parity(data)) { + ps2_error = PS2_ERR_PARITY; + return 0; + } + + if (stop_bit != 1) { + ps2_error = PS2_ERR_STARTBIT2; + return 0; + } + + return data; +} + +uint8_t ps2_host_recv_response(void) { + uint32_t frame = 0; + msg_t msg = MSG_OK; + + msg = ibqReadTimeout(&pio_rx_queue, (uint8_t*)&frame, sizeof(uint32_t), TIME_MS2I(100)); + if (msg < MSG_OK) { + ps2_error = PS2_ERR_NODATA; + return 0; + } + + return ps2_get_data_from_frame(frame); +} + +#ifdef BUFFERED_MODE_ENABLE + +bool pbuf_has_data(void) { + osalSysLock(); + bool has_data = !ibqIsEmptyI(&pio_rx_queue); + osalSysUnlock(); + return has_data; +} + +uint8_t ps2_host_recv(void) { + uint32_t frame = 0; + msg_t msg = MSG_OK; + + uint8_t has_data = pbuf_has_data(); + if (has_data) { + msg = ibqReadTimeout(&pio_rx_queue, (uint8_t*)&frame, sizeof(uint32_t), TIME_MS2I(100)); + if (msg < MSG_OK) { + ps2_error = PS2_ERR_NODATA; + return 0; + } + } else { + ps2_error = PS2_ERR_NODATA; + } + + return frame != 0 ? ps2_get_data_from_frame(frame) : 0; +} + +#endif |