diff options
Diffstat (limited to 'keyboards/moon/rules.mk')
| -rw-r--r-- | keyboards/moon/rules.mk | 56 |
1 files changed, 11 insertions, 45 deletions
diff --git a/keyboards/moon/rules.mk b/keyboards/moon/rules.mk index 699fc33957..3c67b3c287 100644 --- a/keyboards/moon/rules.mk +++ b/keyboards/moon/rules.mk @@ -1,59 +1,16 @@ -# Project specific files -SRC += i2c_master.c pca9555.c matrix.c - # MCU name MCU = atmega32u4 -# Processor frequency. -# This will define a symbol, F_CPU, in all source code files equal to the -# processor frequency in Hz. You can then use this symbol in your source code to -# calculate timings. Do NOT tack on a 'UL' at the end, this will be done -# automatically to create a 32-bit value in your source code. -# -# This will be an integer division of F_USB below, as it is sourced by -# F_USB after it has run through any CPU prescalers. Note that this value -# does not *change* the processor frequency - it should merely be updated to -# reflect the processor speed set externally so that the code can use accurate -# software delays. -F_CPU = 16000000 - - -# -# LUFA specific -# -# Target architecture (see library "Board Types" documentation). -ARCH = AVR8 - -# Input clock frequency. -# This will define a symbol, F_USB, in all source code files equal to the -# input clock frequency (before any prescaling is performed) in Hz. This value may -# differ from F_CPU if prescaling is used on the latter, and is required as the -# raw input clock is fed directly to the PLL sections of the AVR for high speed -# clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL' -# at the end, this will be done automatically to create a 32-bit value in your -# source code. -# -# If no clock division is performed on the input clock inside the AVR (via the -# CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU. -F_USB = $(F_CPU) - -# Interrupt driven control endpoint task(+60) -OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT - - # Bootloader selection # Teensy halfkay # Pro Micro caterina # Atmel DFU atmel-dfu # LUFA DFU lufa-dfu # QMK DFU qmk-dfu -# atmega32a bootloadHID +# ATmega32A bootloadHID +# ATmega328P USBasp BOOTLOADER = atmel-dfu - -# Supported layouts -LAYOUTS = tkl_ansi tkl_iso - # Build Options # change yes to no to disable # @@ -74,4 +31,13 @@ BLUETOOTH_ENABLE = no # Enable Bluetooth with the Adafruit EZ-Key HID AUDIO_ENABLE = no # Audio output on port C6 FAUXCLICKY_ENABLE = no # Use buzzer to emulate clicky switches HD44780_ENABLE = no # Enable support for HD44780 based LCDs (+400) + +# custom matrix setup CUSTOM_MATRIX = yes + +VPATH += drivers/gpio +SRC += pca9555.c matrix.c +QUANTUM_LIB_SRC += i2c_master.c + +# Supported layouts +LAYOUTS = tkl_ansi tkl_iso |