summaryrefslogtreecommitdiff
path: root/converter/ps2_usb
diff options
context:
space:
mode:
Diffstat (limited to 'converter/ps2_usb')
-rw-r--r--converter/ps2_usb/Makefile4
-rw-r--r--converter/ps2_usb/README.md2
-rw-r--r--converter/ps2_usb/config.h6
3 files changed, 6 insertions, 6 deletions
diff --git a/converter/ps2_usb/Makefile b/converter/ps2_usb/Makefile
index edcbddfdfa..51b2225661 100644
--- a/converter/ps2_usb/Makefile
+++ b/converter/ps2_usb/Makefile
@@ -87,8 +87,8 @@ NKRO_ENABLE = yes # USB Nkey Rollover - not yet supported in LUFA
# PS/2 Options
#
-PS2_USE_USART = yes # uses hardware USART engine for PS/2 signal receive(recomened)
-#PS2_USE_INT = yes # uses external interrupt for falling edge of PS/2 clock pin
+#PS2_USE_USART = yes # uses hardware USART engine for PS/2 signal receive(recomened)
+PS2_USE_INT = yes # uses external interrupt for falling edge of PS/2 clock pin
#PS2_USE_BUSYWAIT = yes # uses primitive reference code
diff --git a/converter/ps2_usb/README.md b/converter/ps2_usb/README.md
index 8a535949d8..74464e2640 100644
--- a/converter/ps2_usb/README.md
+++ b/converter/ps2_usb/README.md
@@ -14,7 +14,7 @@ In case of Teensy2.0(ATMega32U4):
- **USART**: **Clock** is on `PD5` and **Data** on `PD2`.
3. Optionally you need pull-up resistor. 1K-10K Ohm is OK.
-To change pin configuration edit config.h.
+To change pin configuration edit **config.h** and **Makefile**.
Build Firmware
diff --git a/converter/ps2_usb/config.h b/converter/ps2_usb/config.h
index c9bab1b072..c0a4fab13b 100644
--- a/converter/ps2_usb/config.h
+++ b/converter/ps2_usb/config.h
@@ -50,11 +50,11 @@ along with this program. If not, see <http://www.gnu.org/licenses/>.
#define PS2_CLOCK_PORT PORTD
#define PS2_CLOCK_PIN PIND
#define PS2_CLOCK_DDR DDRD
-#define PS2_CLOCK_BIT 5
+#define PS2_CLOCK_BIT 1
#define PS2_DATA_PORT PORTD
#define PS2_DATA_PIN PIND
#define PS2_DATA_DDR DDRD
-#define PS2_DATA_BIT 2
+#define PS2_DATA_BIT 0
#endif
/*
@@ -69,7 +69,7 @@ along with this program. If not, see <http://www.gnu.org/licenses/>.
#define PS2_DATA_PORT PORTD
#define PS2_DATA_PIN PIND
#define PS2_DATA_DDR DDRD
-#define PS2_DATA_BIT 2
+#define PS2_DATA_BIT 0
#define PS2_INT_INIT() do { \
EICRA |= ((1<<ISC11) | \
(0<<ISC10)); \