Merge pull request #34 from jackhumbert/tmk-master

merging from tmk, new_project script and template

1 files changed, 0 insertions, 30 deletions

diff --git a/protocol/lufa/LUFA-120730/LUFA/DoxygenPages/ProgrammingApps.txt b/protocol/lufa/LUFA-120730/LUFA/DoxygenPages/ProgrammingApps.txt
deleted file mode 100644
index 6ff1856766..0000000000
--- a/protocol/lufa/LUFA-120730/LUFA/DoxygenPages/ProgrammingApps.txt
+++ /dev/null
@@ -1,30 +0,0 @@
-/** \file

- *

- *  This file contains special DoxyGen information for the generation of the main page and other special

- *  documentation pages. It is not a project source file.

- */

-

-/** \page Page_ProgrammingApps Programming an Application into a USB AVR

- *

- *  Once you have built an application, you will need a way to program in the resulting ".HEX" file (and, if your

- *  application uses EEPROM variables with initial values, also a ".EEP" file) into your USB AVR. Normally, the

- *  reprogramming of an AVR device must be performed using a special piece of programming hardware, through one of the

- *  supported AVR programming protocols - ISP, HVSP, HVPP, JTAG, dW or PDI. This can be done through a custom programmer,

- *  a third party programmer, or an official Atmel AVR tool - for more information, see the <a>atmel.com</a> website.

- *

- *  Alternatively, you can use the bootloader. From the Atmel factory, each USB AVR comes preloaded with the Atmel

- *  DFU (Device Firmware Update) class bootloader, a small piece of AVR firmware which allows the remainder of the

- *  AVR to be programmed through a non-standard interface such as the serial USART port, SPI, or (in this case) USB.

- *  Bootloaders have the advantage of not requiring any special hardware for programming, and cannot usually be erased

- *  or broken without an external programming device. They have disadvantages however; they cannot change the fuses of

- *  the AVR (special configuration settings that control the operation of the chip itself) and a small portion of the

- *  AVR's FLASH program memory must be reserved to contain the bootloader firmware, and thus cannot be used by the

- *  loaded application.

- *

- *  If you wish to use the DFU bootloader to program in your application, refer to your DFU programmer's documentation.

- *  Atmel provides a free utility called FLIP which is USB AVR compatible, and an open source (Linux compatible)

- *  alternative exists called "dfu-programmer".

- *

- *  \see \ref Page_BuildModule_DFU for information on the LUFA build system DFU module, for automatic DFU bootloader

- *  programming makefile targets.

- */