/*
Copyright 2021 mtei

This program is free software: you can redistribute it and/or modify
it under the terms of the GNU General Public License as published by
the Free Software Foundation, either version 2 of the License, or
(at your option) any later version.

This program is distributed in the hope that it will be useful,
but WITHOUT ANY WARRANTY; without even the implied warranty of
MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
GNU General Public License for more details.

You should have received a copy of the GNU General Public License
along with this program.  If not, see <http://www.gnu.org/licenses/>.
*/

#pragma once

#include "config_common.h"

/* key matrix size */
#define MATRIX_ROWS 5
#define MATRIX_COLS 16

/* Proton-C **************************
                 ====
         +-------====------+
   DEBUG | A9/TX/SCL2   5V | (VUSB)
         | A10/RX/SDA2 GND |
         | GND       FLASH |
         | GND        3.3V | (VCC)
     C15 | B7/SDA1      A2 | C0
     C14 | B6/SCL1      A1 | C1
     C13 | B5           A0 | C2
     C12 | B4      SCL1/B8 | C3
     C11 | B3     SCLK/B13 | C4
     C10 | B2     MISO/B14 | C5
     C9  | B1     MOSI/B15 | C6
     C8  | B0      SDA1/B9 | C7
         +---+         +---+
         +---+         +---+
      R0 | A4          B10 |
      R1 | A5          B11 |
      R2 | A6          B12 |
      R3 | A7          A14 |
      R4 | A8          A13 |
         | A15         RST |
         +-----------------+
***************************************/


/* COL2ROW, ROW2COL */
#define DIODE_DIRECTION COL2ROW

/*
 * Split Keyboard specific options, make sure you have 'SPLIT_KEYBOARD = yes' in your rules.mk, and define SOFT_SERIAL_PIN.
 */
//#define SOFT_SERIAL_PIN D0  // or D1, D2, D3, E6

//#define BACKLIGHT_PIN B7
//#define BACKLIGHT_LEVELS 3
//#define BACKLIGHT_BREATHING

//#define RGB_DI_PIN E2
//#ifdef RGB_DI_PIN
//#    define RGBLED_NUM 16
//#    define RGBLIGHT_HUE_STEP 8
//#    define RGBLIGHT_SAT_STEP 8
//#    define RGBLIGHT_VAL_STEP 8
//#    define RGBLIGHT_LIMIT_VAL 255 /* The maximum brightness level */
//#    define RGBLIGHT_SLEEP  /* If defined, the RGB lighting will be switched off when the host goes to sleep */
/*== customize breathing effect ==*/
/*==== (DEFAULT) use fixed table instead of exp() and sin() ====*/
//#    define RGBLIGHT_BREATHE_TABLE_SIZE 256      // 256(default) or 128 or 64
/*==== use exp() and sin() ====*/
//#    define RGBLIGHT_EFFECT_BREATHE_CENTER 1.85  // 1 to 2.7
//#    define RGBLIGHT_EFFECT_BREATHE_MAX    255   // 0 to 255
//#endif

/* Debounce reduces chatter (unintended double-presses) - set 0 if debouncing is not needed */
#define DEBOUNCE 5

/* define if matrix has ghost (lacks anti-ghosting diodes) */
//#define MATRIX_HAS_GHOST

/* Mechanical locking support. Use KC_LCAP, KC_LNUM or KC_LSCR instead in keymap */
#define LOCKING_SUPPORT_ENABLE
/* Locking resynchronize hack */
#define LOCKING_RESYNC_ENABLE

/* If defined, GRAVE_ESC will always act as ESC when CTRL is held.
 * This is useful for the Windows task manager shortcut (ctrl+shift+esc).
 */
//#define GRAVE_ESC_CTRL_OVERRIDE

/*
 * Force NKRO
 *
 * Force NKRO (nKey Rollover) to be enabled by default, regardless of the saved
 * state in the bootmagic EEPROM settings. (Note that NKRO must be enabled in the
 * makefile for this to work.)
 *
 * If forced on, NKRO can be disabled via magic key (default = LShift+RShift+N)
 * until the next keyboard reset.
 *
 * NKRO may prevent your keystrokes from being detected in the BIOS, but it is
 * fully operational during normal computer usage.
 *
 * For a less heavy-handed approach, enable NKRO via magic key (LShift+RShift+N)
 * or via bootmagic (hold SPACE+N while plugging in the keyboard). Once set by
 * bootmagic, NKRO mode will always be enabled until it is toggled again during a
 * power-up.
 *
 */
//#define FORCE_NKRO

/*
 * Feature disable options
 *  These options are also useful to firmware size reduction.
 */

/* disable debug print */
//#define NO_DEBUG

/* disable print */
//#define NO_PRINT

/* disable action features */
//#define NO_ACTION_LAYER
//#define NO_ACTION_TAPPING
//#define NO_ACTION_ONESHOT

/* Bootmagic Lite key configuration */
//#define BOOTMAGIC_LITE_ROW 0
//#define BOOTMAGIC_LITE_COLUMN 0

#ifdef DEBUG_CONFIG
#    define MATRIX_DEBUG_PIN A9
#    include "../debug_config.h"
#endif