# Polyandry/polypad

![Polyandry](https://1.bp.blogspot.com/-97uoICZvZec/XSdpvCVFFlI/AAAAAAACVZY/BlCRjxjDqDAxOZa6C5ddQr0OsFQ9VZv5wCLcBGAs/s1600/d1.jpg)
===

3x4/4x3 grid layout, multiple controllers supported
- Pro Micro
- PJRC Teensy 2.0

(**The below are not currently ported:**)

- PJRC Teensy LC/3.2 
- PJRC Teensy 3.5/3.6
- Adafruit ItsyBitsy ATMega32u4
- Adafruit ItsyBitsy M0
- Adafruit ItsyBitsy M4

The matrix is electrically 1x12 with no diodes, with a thirteenth pin used for the column rather than a ground in order to be compatible with all the listed microcontrollers..

The default keymap is a testing keymap that is intended to make sure all of the keys on the matrix are working and properly assigned.

[The original (minimal arduino sketch) firmware, with support for some unsupported controllers](https://git.40percent.club/di0ib/Misc/src/branch/master/polyandry)

Keyboard Maintainer: QMK Community  
Hardware Supported: Polyandry PCB  
Hardware Availability: [Polyandry gerbers are on 40percent.club](https://www.40percent.club/2019/07/polyandry.html)

Make example for this keyboard (after setting up your build environment):

    make 40percentclub/polyandry:default 
    or
    qmk compile -kb 40percentclub/polyandry -km default

Default firmware is for an Arduino Pro Micro knockoff.

If you would like to specify a controller:

    make 40percentclub/polyandry/promicro:default 
    or
    qmk compile -kb 40percentclub/polyandry/promicro -km default
    make 40percentclub/polyandry/teensy2:default 
    or
    qmk compile -kb 40percentclub/polyandry/teensy2 -km default

## Bootloader

Enter the bootloader in 3 ways: 

*  **Bootmagic reset**: Hold down the top left key of the keyboard (top right or bottom left in horizontal configuration)
* **Physical reset**: Briefly press the button on the bottom of the microcontroller or, if not present short the pin marked RST to a GND.
* **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available

See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).