From e47ab6a5752e16bd3b4288153798c12af1bee3d5 Mon Sep 17 00:00:00 2001 From: Wilba Date: Sat, 12 Oct 2019 15:37:03 +1100 Subject: [Keyboard] wilba.tech PCB refactoring (#6982) * Cleanup * Refactor VIA rules.mk * WT mono backlight refactor, VIA support * Added WT75-C * Fixed compile error * Cleanup rules.mk * Review changes * Review changes --- keyboards/wilba_tech/zeal60/rules.mk | 46 +++++++----------------------------- 1 file changed, 8 insertions(+), 38 deletions(-) (limited to 'keyboards/wilba_tech/zeal60') diff --git a/keyboards/wilba_tech/zeal60/rules.mk b/keyboards/wilba_tech/zeal60/rules.mk index 5d20659f83..b8d63050c6 100644 --- a/keyboards/wilba_tech/zeal60/rules.mk +++ b/keyboards/wilba_tech/zeal60/rules.mk @@ -1,5 +1,3 @@ - - # project specific files SRC = keyboards/wilba_tech/wt_main.c \ keyboards/wilba_tech/wt_rgb_backlight.c \ @@ -10,42 +8,14 @@ SRC = keyboards/wilba_tech/wt_main.c \ # MCU name MCU = atmega32u4 -# Processor frequency. -# This will define a symbol, F_CPU, in all source code files equal to the -# processor frequency in Hz. You can then use this symbol in your source code to -# calculate timings. Do NOT tack on a 'UL' at the end, this will be done -# automatically to create a 32-bit value in your source code. -# -# This will be an integer division of F_USB below, as it is sourced by -# F_USB after it has run through any CPU prescalers. Note that this value -# does not *change* the processor frequency - it should merely be updated to -# reflect the processor speed set externally so that the code can use accurate -# software delays. -F_CPU = 16000000 - -# -# LUFA specific -# -# Target architecture (see library "Board Types" documentation). -ARCH = AVR8 - -# Input clock frequency. -# This will define a symbol, F_USB, in all source code files equal to the -# input clock frequency (before any prescaling is performed) in Hz. This value may -# differ from F_CPU if prescaling is used on the latter, and is required as the -# raw input clock is fed directly to the PLL sections of the AVR for high speed -# clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL' -# at the end, this will be done automatically to create a 32-bit value in your -# source code. -# -# If no clock division is performed on the input clock inside the AVR (via the -# CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU. -F_USB = $(F_CPU) - -# Interrupt driven control endpoint task(+60) -OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT - -# Boot Section +# Bootloader selection +# Teensy halfkay +# Pro Micro caterina +# Atmel DFU atmel-dfu +# LUFA DFU lufa-dfu +# QMK DFU qmk-dfu +# ATmega32A bootloadHID +# ATmega328P USBasp BOOTLOADER = atmel-dfu # Do not put the microcontroller into power saving mode -- cgit v1.2.3