From c6e291c4162bae29266cdf980657eb6a5738dfda Mon Sep 17 00:00:00 2001 From: Wolf Van Herreweghe Date: Thu, 8 Dec 2022 17:12:49 +0100 Subject: Revert RESET-> QK_BOOT in Read Me files where applicable (#19262) --- keyboards/handwired/axon/readme.md | 4 ++-- keyboards/handwired/swiftrax/digicarp65/readme.md | 2 +- 2 files changed, 3 insertions(+), 3 deletions(-) (limited to 'keyboards/handwired') diff --git a/keyboards/handwired/axon/readme.md b/keyboards/handwired/axon/readme.md index d48297b4f7..ca422130ef 100644 --- a/keyboards/handwired/axon/readme.md +++ b/keyboards/handwired/axon/readme.md @@ -15,8 +15,8 @@ Make example for this keyboard (after setting up your build environment): ## To reset into bootloader mode: 1. While plugged in, press and hold `BOOT` switch -2. While holding `BOOT`, press `QK_BOOT` and hold it for a second or two -3. Release `QK_BOOT` +2. While holding `BOOT`, press `RESET` and hold it for a second or two +3. Release `RESET` 4. Release `BOOT` 5. The keyboard should now be recognized as a USBasp programmer device. diff --git a/keyboards/handwired/swiftrax/digicarp65/readme.md b/keyboards/handwired/swiftrax/digicarp65/readme.md index 34e0c0b755..a10c1b567a 100644 --- a/keyboards/handwired/swiftrax/digicarp65/readme.md +++ b/keyboards/handwired/swiftrax/digicarp65/readme.md @@ -17,5 +17,5 @@ See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_to Enter the bootloader in 3 ways: * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (top left key)and plug in the keyboard -* **Physical reset button**: Briefly short the pad on the back of the PCB labeled QK_BOOT +* **Physical reset button**: Briefly short the pad on the back of the PCB labeled `RESET` * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available -- cgit v1.2.3