1 files changed, 0 insertions, 66 deletions
diff --git a/keyboards/ergodox_infinity/readme.md b/keyboards/ergodox_infinity/readme.md
deleted file mode 100644
index c51bdd7c82..0000000000
--- a/keyboards/ergodox_infinity/readme.md
+++ /dev/null
@@ -1,66 +0,0 @@
-# ErgoDox Infinity
-
-The Infinity is two completely independent keyboards, and needs to be flashed
-for the left and right halves seperately.  To flash them:
-
-  - Make sure you are in the top-level qmk_firmware directory
-
-  - Build the firmware with `make ergodox_infinity:keymapname`
-
-  - Plug in the left hand keyboard only.
-
-  - Press the program button (back of keyboard, above thumb pad).
-
-  - Install the firmware with `sudo make ergodox_infinity:keymapname:dfu-util`
-
-  - Plug in the right hand keyboard only.
-
-  - Press the program button (back of keyboard, above thumb pad).
-
-  - Install the firmware with `sudo make ergodox_infinity:keymapname:dfu-util`
-
-More information on the Infinity firmware is available in the [TMK/chibios for
-Input Club Infinity Ergodox](https://github.com/fredizzimo/infinity_ergodox/blob/master/README.md)
-
-## Infinity Two Halves
-
-The Infinity is two completely independent keyboards, that can connect together.
-You have a few options in how you flash the firmware:
-
-- Add `#define EE_HANDS` to your config.h, initialize the EEPROM values (see below),
-  and then flash the same firmware to both halves.
-
-- Flash with the instructions above, which assume the left hand is connected to USB.
-
-- For minor changes such as changing only the keymap without having updated
-  any part of the firmware code itself, you can program only the half connected to USB,
-  but it is safest to program both halves.
-
-### EE_HANDS initialization
-
-To initialize the EEPROM values for `EE_HANDS` to work properly, these steps should work.
-They only need to be done once, unless you reset the EEPROM later.
-
-  - Plug in the left keyboard half to the computer, and press its program button.
-
-  - Flash the left half with `make ergodox_infinity:default:dfu-util-split-left`
-    (If you need to use a different method to flash your keyboard, still run this command,
-    and abort it with Ctrl+C when the flashing attempts starts to print errors,
-    then flash the built firmware).
-
-  - On the left half, press the top vertical 1.5U key (second from the top in the rightmost column) once,
-    then the 1U key at the bottom in the opposite corner (bottom left corner).
-
-  - Plug in the right keyboard half to the computer, and press its program button.
-
-  - Flash the right half with `make ergodox_infinity:default:dfu-util-split-right`
-
-  - On the right half, press the top vertical 1.5U key (second from the top in the leftmost column) once,
-    then the 1U key at the bottom in the opposite corner (bottom right corner).
-
-  - Add `#define EE_HANDS` to the config.h file of your keymap, and build your firmware using
-    `make ergodox_infinity:keymapname`.
-
-  - After this, you can flash both halves with the same firmware, _without_ risking a mirrored keyboard when connected the wrong way.
-    If you reset your EEPROM later, you'll have to follow these steps again, though.
-